How to Clean and Dust the Bitmain Antminer E9?

How to Clean and Dust the Bitmain Antminer E9?

To expand the lifespan of your Bitmain Antminer E9, it’s necessary to clean the miner monthly. This guide will show you how to clean and dust the Bitmain Antminer E9.

Today, we’re diving into an essential topic for all proud owners of the powerful Bitmain Antminer E9: cleaning and dusting. Regular maintenance plays a crucial role in ensuring optimal performance and longevity of your ASIC miner. In this blog post, we’ll walk you through why it’s important to keep your Antminer E9 clean and provide a comprehensive guide on how to effectively clean and dust your device. Let’s get started!

When Should I Clean and Dust the Miners?

Before we jump into the cleaning process, let’s briefly discuss why it’s essential to keep your Antminer E9 clean and dust-free:

  1. Efficiency and Performance: Dust accumulation can hinder airflow and cause overheating, resulting in reduced mining efficiency. By cleaning your Antminer E9, you can restore proper airflow and help maintain optimal mining performance.
  2. Component Longevity: Dust particles can settle on sensitive components such as fans, heat sinks, and circuit boards, leading to increased wear and potential damage over time. Regular cleaning helps prolong the lifespan of your Antminer E9.
  3. Safety: Accumulated dust poses a fire hazard, particularly when combined with heat generated by the mining process. Keeping your device clean reduces the risk of electrical malfunctions or fires.

Now that we understand the importance of cleaning, let’s proceed to the step-by-step cleaning guide.

*IMPORTANT: It’s important to stop the miners.

How to Clean and Dust?

Step 1: Preparation

  • Soft brush (e.g., paintbrush or makeup brush)
  • Air Compressor + Air Gun: Air Pressure range: 0.7 +/- 0.05 MPa
  • Microfiber cloth
  • Isopropyl alcohol (90% concentration or higher)
  • Cotton swabs

Step 2: Power Down and Unplug

To ensure your safety, power down your Antminer E9 and unplug it from the power source. Wait for a few minutes to let any residual electrical charge dissipate.

Step 3: Exterior Cleaning

Using the soft brush, gently remove dust from the exterior surfaces of your Antminer E9, paying special attention to the ventilation areas, fan grills, and any visible accumulation.

Step 4: Compressed Air for Dust Removal

Use the air gun to gently blow the front and rear fans twice


To prevent damage, position the air gun close to the fan and take care not to touch the grille or fan blades. Blow each gap for two to three seconds, then repeat the procedure two or three times.


Step 5: Deep Cleaning

Moisten the microfiber cloth with isopropyl alcohol, ensuring it’s not dripping wet. Carefully wipe down the fan blades, heat sinks, and other accessible surfaces to remove any stubborn dust or residue.

Step 6: Detail Cleaning

For tiny crevices and hard-to-reach spots, dip a cotton swab in isopropyl alcohol and gently clean the areas, ensuring not to apply excessive force.

Step 7: Final Checks

Once you’ve completed the cleaning process, double-check that no moisture or cleaning agents are left on the surfaces. Ensure everything is dry before reconnecting and powering up your Antminer E9.


Congratulations! You’ve successfully learned how to clean and dust your Bitmain Antminer E9. By regularly maintaining your ASIC miner, you’ll not only enhance its performance but also extend its lifespan, ensuring efficient and trouble-free mining for years to come. Remember to schedule regular cleaning sessions to keep your Antminer E9 in top-notch condition. Happy mining!

Disclaimer: When cleaning your Antminer E9, exercise caution and follow proper safety protocols. If you’re unsure or uncomfortable with the process, consider seeking assistance from a professional.

Scroll to Top